2002 Ski-Doo Shop Manual Volume Three, Page 188Get this manual
Subsection 10
Section 04 ENGINE (CARBURETOR AND FUEL PUMP)
As confirmation, the gap between the stopper and the bracket should be in between and 0.5 mm (0 and 164 in)
Idle Speed Final Adjustment
CAUTION: Before starting engine for the final idle adjustment, make sure that oil pump is adjustedThe oil injection pump adjustment must be checked after each time carburetor idle is adjustedRefer to OIL INJECTION SYSTEMStart engine and allow it to warm then adjust idle speed to specifications by turning idle speed screw clockwise to increase engine speed or counterclockwise to decrease itRefer to TECHNICAL DATA for the specificationsCAUTION: Do not attempt to set the idle speed by using the pilot screwSevere engine damage can occur
Some Models
A32C32A
TESTING
Solenoid is supplied by the MPEMIf this MPEM does not work, there will be no current on the compensation solenoidAir temperature sensor must be at room temperatureOperate the engine at 4000 RPMThe solenoid must vibrateStart the engine and observe the solenoidA vibrating solenoid indicates that the MPEM is in good working orderIf not, replace the MPEM and repeat test