2002 Ski-Doo Shop Manual Volume Three, Page 183Get this manual
Section 04 ENGINE Subsection 10 (CARBURETOR AND FUEL PUMP)
DISASSEMBLY AND ASSEMBLY
NOTE: To ease the carburetor disassembly and assembly procedures it is recommended to use carburetor tool kit (PN 404 112 000)
24, Starter Jet
Starter jet is part of choke systemUse wide flat screwdriver for disassembly and assemblyOn some models there is no starter jet no24; instead, hole in float bowl no29 acts as starter jet1 2
A00B2FA
29, Float Bowl
Unscrew drain screw no31 and screw no30Remove float bowlSome float bowls have an integrated starter jet no24In these cases do not mismatch float bowl
27, Float and Needle Valve Ass'y
Unfasten both screws then, pull out float and needle valve ass'y no27At assembly, apply Loctite 243 on screw threadsA32C3MA