2002 Ski-Doo Shop Manual Volume Three, Page 173Get this manual
Section 04 ENGINE Subsection 10 (CARBURETOR AND FUEL PUMP)
IDENTIFICATION
All carburetors are identified on their body
CLEANING AND INSPECTION
The entire carburetor should be cleaned with general solvent and dried with compressed air before disassemblyCAUTION: Heavy duty carburetor cleaner may be harmful to the float material and to the rubber parts, O-rings, etcTherefore, it is recommended to remove those parts prior to cleaningCarburetor body and jets should be cleaned in carburetor cleaner following manufacturer's instructions
WARNING
Solvent with low flash point such as gasoline, naphtha, benzol, etc should not be used as they are flammable and explosiveA01C59A
TYPICAL 1Identification: 34-482
REMOVAL
Unfasten clamps then, remove air silencer from left hand sideDisconnect fuel inlet lines