2002 Ski-Doo Shop Manual Volume Three, Page 159Get this manual
Section 04 ENGINE Subsection 07 (AXIAL FAN COOLING SYSTEM)
Support fan housing no12 with ringWith punch, working all around bearing no10 inner race, drive bearing out of fan housingKeep shims for installation
Using fan holder tool (PN 420 876 357), remove fan nutRemove fan with pulley half
A23C07A
1Ring supporting fan housing
A03C22A
Remove circlip no11 then remaining bearingTo install, press one bearing in place then install circlip and shimsPress the other bearing from opposite side until it is flush with housingPress fan shaft from engine side of fan housingCheck for free rolling action
1Remove fan with pulley half