2002 Ski-Doo Shop Manual Volume One, Page 348Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
To remove decal; heat old decal with heat gun and peel off slowlyUsing isopropyl alcohol, clean the surface and dry thoroughlyApply liquid soap to new decal and carefully position the decalUsing sponge or squeegee, remove the air bubbles and surplus water working from the center toward the edgesAllow to air dryCAUTION: Do not apply isopropyl alcohol or solvent directly on decals
WARNING
Before installation, ensure that all cables are in perfect conditionProperly install the cable ends and secure them in placePay attention to route them properly, away from any rotating, moving, heating, or vibrating parts
WARNING
Always ensure that the fuel, vent, primer, impulse, injection oil and rotary valve oil lines are properly fixed to their connectors, that they are not perforated or kinked and that they are properly routed away from any rotating, moving, heating or vibrating partsAlso check for leaksReplace if requiredNOTE: Refer to proper Parts Catalog to find suitable clip part numbers