2002 Ski-Doo Shop Manual Volume One, Page 336Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
WARNING
Ball joint sockets must run parallel with steering arm and pivot armTie rod must be restrained when tightening lock nutsA 1
A02G0SA
A20 mm (2532 in) maximum
Restrain short tie rod while torquing nuts so that ball joint sockets run parallel with steering arm and pivot armEnsure that pivot arm is still centered and check ski toe-outTOE-OUT ADJUSTMENT Raise front of vehicle so that skis are off the groundLoosen lock nuts of long tie rods and turn each tie rod so that skis are in straight ahead positionTo adjust toe-out, slightly turn both tie rods exactly the same amountMake sure external threaded length not engaged is not too long and torque nuts as specified aboveA05G09B