2002 Ski-Doo Shop Manual Volume One, Page 323Get this manual
Section 07 REAR SUSPENSION Subsection 04 (DRIVE AXLE)
All Models Ensure to align indexing marks of each sprocket when assembling
A00F0CA
1Grease seal type 2Oil seal type
11, Bearing Protector
A24D05A
TYPICAL 1Indexing marks aligned
At assembly, flat side of bearing protector must be against bearing
The maximum desynchronization for the sprockets is 1.5 mm (116 in)To check this tolerance, place axle assembly on plane surface and measure the gap between sprocket tooth and surface
5,12, Bearing
Always push bearing by inner race
A00F0DA