2002 Ski-Doo Shop Manual Volume One, Page 321Get this manual
Section 07 REAR SUSPENSION Subsection 04 (DRIVE AXLE)
REMOVAL
Tundra and Skandic LT Drain oil from chaincaseRelease drive chain tensionRemove chaincase coverRaise and block rear of vehicle off the groundRemove suspensionRefer to SUSPENSION
Remove screws retaining ball bearing housing then, remove inner plate no3Remove drive axle
DISASSEMBLY
4, Speedometer Drive Insert
Remove speedometer drive insert
2,8, End Bearing Housing and Seal
Remove cable protector no7, and plastic bearing coverRemove circlip no14 from drive axleRemove chain and sprocket then circlip and bearing no12 from drive axlePry oil seals from chaincase and end bearing housing
5,12, Bearing
To remove bearings, use puller assembly, ring and half rings as illustrated
6,9,13, Drive Axle and Sprocket