2002 Ski-Doo Shop Manual Volume One, Page 285Get this manual
Section 06 ELECTRICAL Subsection 05 (ELECTRIC STARTER)
Slide yoke over armatureInstall brush holder then brushes in their housingsInsert springs as follows: place one end of spring against brush, compress, then push the other end of spring onto its housingRepeat for remaining springs
INSTALLATION
Make sure that starter and engine mating surfaces are free of grimeSerious trouble may arise if starter is not properly alignedInstall starterNOTE: Check proper engaging depth of starter pinion teeth to ring gear teeth (see illustration)Install hardened washers (PN 503 007 900) between engine and starter supports accordinglyCAUTION: All starter bracket fasteners must be secured with Loctite 271 (PN 293 800 005)2 1
A19E04A