2002 Ski-Doo Shop Manual Volume One, Page 231Get this manual
Section 05 TRANSMISSION Subsection 06 (BRAKE)
INSTALLATION
To install brake, reverse removal procedure paying attention to the following
WARNING
Avoid getting oil on brake padsDo not lubricate or apply antirust or antifreeze solution in brake cable
17, Brake Disc
Skandic LT The brake disc must be floating on countershaft for efficient operation of brakeApply anti-seize lubricant (PN 413 701 000) on shaft and check that disc slides freelyThe disc hub exceeds the disc more from one side than from the otherInstall disc with the longer exceeding portion toward driven pulleyPush O-rings inside disc hub
A15D03A
TYPICAL 1Fixed pad 2Inner caliper A1 mm (132 in) minimum
Models with Hydraulic Brake Brake pads must be replaced when lining is mm (132 in) thickCAUTION: Brake pads must always be replaced in pairs