2002 Ski-Doo Shop Manual Volume One, Page 217Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
2,4,5, Roller Pin, Outer Cam and Spring
Insert spring in adjusting hole no3 into sliding half, as illustratedADJUSTMENT
11,12, Shim
NOTE: The following adjustment must be performed with new drive beltFor best performance, particularly at starting, top of drive belt should be flush with top of driven pulley halves
A05D12A
1Adjusting hole no3
Insert other spring end in camMount driven pulley spring compressor (PN 529 035 300) as in Disassembly procedurePush cam all the way in then install roll pin coated with anti-seize lubricant (PN 413 701 000)