2002 Ski-Doo Shop Manual Volume One, Page 211Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
Install fork (PN 529 005 500) into slider shoe grooves to maintain them for governor cup installationProceed on set of slider shoes
INSTALLATION
WARNING
Do not apply anti-seize or any lubricant on crankshaft and drive pulley tapers
529 005 500
WARNING
Never use any type of impact wrench at drive pulley removal and installationClean mounting surfaces as described in CLEANING above
Drive Pulley Ass'y
A16B02A
Make sure to align governor cup arrow with sliding half and fixed half markNOTE: If fixed half has no mark, align governor cup mark with segment no1 of inner halfSegments are identified on engine side
The following installation procedure must be strictly adhered toInstall drive pulley on crankshaft extensionInstall new conical spring washer with its concave side towards drive pulley then install screw