2002 Ski-Doo Shop Manual Volume One, Page 210Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
CAUTION: Lever ass'y and rollers must move easily after installation
5,6,18,19, Fixed Half, Sliding Half, Spring, Spring Cover and Screw
To install spring cover, use spring compressor (PN 529 035 524)Assemble fixed and sliding halvesNote that fixed halves have different cone angleMatch cone angle with crankshaftLift sliding half against spring cover and align spring cover arrow with sliding half markA16D09A
1Equal distance
Torque screws to 10 Nm (89 lbfin)
9,11,13,14, Screw, Lever Ass'y, Nut and Cotter Pin
Always install lever assemblies so that cotter pins are on the shown sideInstall cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever
WARNING