2002 Ski-Doo Shop Manual Volume One, Page 198Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
Identify blocks no1 and their respective positive positions for reassembly
INSPECTION
Check sliding half for excessive lateral play and fixed half shaft for scratchesReplace as required
ASSEMBLY
Install circlip no10 then guide washer no11Make sure to install blocks at their original position and with their curved end toward governor cupSee following illustrationScrew spring cover to to mm (116 to 18 in) down below sliding half endApply Loctite 271 on screw threadsInstall set screw aligned with spring cover slot1 A
A05D0LA
1Identify
2, Cap, Washer and Disk
These are calibration partsRefer to TECHNICAL DATAUnscrew set screw no4 then use spring cover tool (PN 529 027 300) to unscrew spring cover no5Mount tool in vise for cover hand-unscrewing