2002 Ski-Doo Shop Manual Volume One, Page 194Get this manual
Section 05 TRANSMISSION Subsection 02 (DRIVE BELT)
DRIVE BELT HEIGHT MEASUREMENT AND ADJUSTMENT
Measurement
Before checking the belt height, ensure that goodcondition proper belt (refer to the application chart) is installedAdjust pulley distance and alignmentRefer to PULLEY DISTANCE AND ALIGNMENTTo obtain maximum vehicle performance, the belt height must be adjusted according to specifications shown in the accompanying chartMODEL All models BELT HEIGHT mm (in) Top edge of drive belt cord should be flush with driven pulley edge
All Models Vary pulley distance within tolerances to obtain proper drive belt height
DRIVE BELT DEFLECTION MEASUREMENT (reference only)
IMPORTANT: The drive belt deflection will be automatically set after performing the pulley distance and belt height adjustmentsThe following procedure will confirm proper pulley distance and belt height adjustmentNOTE: To obtain an accurate drive belt deflection measurement, it is suggested to allow break-in period of 50 km (30 mBefore checking the belt deflection, ensure that good-condition proper belt (Refer to the application chart) is installedAdjust pulley distance and alignmentRefer to PULLEY DISTANCE AND ALIGNMENTMODEL Tundra All Skandic DEFLECTION mm (in) 32 (1-14 1364) 32 (1-14 1364) FORCE kg (lb) 6.8 (15) 11.3 (25)