2002 Ski-Doo Shop Manual Volume One, Page 185Get this manual
Section 04 ENGINE Subsection 11 (CARBURETOR AND FUEL PUMP)
Final idle speed adjustment (engine running at idle speed) should be within 12 turn of idle speed screw from preliminary adjustmentMODELS Tundra Skandic WTSWTWT LC Skandic LT THROTTLE SLIDE HEIGHT 0.1 mm.004 in) 1.5 (.059) 1.3 (.051)
CAUTION: The rubber flange must be checked for cracks andor damageAt assembly, the flange must be perfectly matched with the air intake manifold or severe engine damage will occurInstall clamps in way that their tightening bolts are staggered not aligned
Throttle Cable Adjustment WARNING
Ensure the engine is turned OFF, prior to performing the throttle cable adjustmentFor maximum performance, correct cable adjustment is criticalAt full opening, throttle slide must be flush or 1.0 mm (.040 in) lower than the top of carburetor outlet bore (engine side)First loosen adjuster nut then turn throttle cable adjuster accordingly1