2002 Ski-Doo Shop Manual Volume One, Page 156Get this manual
Section 04 ENGINE Subsection 06 (CDI SYSTEM)
NOTE: The following procedures can be done without removing the engine from chassisTo facilitate magneto removal, hold drive pulley with proper holding toolCDI means Capacitor Discharge System
CAUTION: Use only M8 20 mm screws to bolt puller to magneto
CLEANING
Clean all metal components in non-ferrous metal cleanerCAUTION: Clean stator and magneto using only clean cloth
DISASSEMBLY
3, Magneto Flywheel
To gain access to magneto assembly, remove the following parts as needed on different engines: tuned pipe and muffler rewind starter starting pulley no2To remove magneto flywheel retaining nut no1: Use magneto puller ring (PN 420 876 080)Former puller has to be modified as shownA06E22B