2001 Ski-Doo Mini Z Factory Shop Manual, Page 145Get this manual
Section 09 BODY AND FRAME Subsection 02 (BODY)
To remove decal; heat old decal with heat gun and peel off slowlyUsing isopropyl alcohol, clean the surface and dry thoroughlyApply liquid soap to new decal and carefully position the decalUsing sponge or squeegee, remove the air bubbles and surplus water working from the center toward the edgesAllow to air dryCAUTION: Do not apply isopropyl alcohol or solvent directly on decals
WINDSHIELD INSTALLATION
When peeling off the protective film some polyethylene particles may remain on the windshield no1A soft clean cloth moistened with naphtha (camping equipment fuel) will easily remove the remaining particlesA31H0KA
VIEW FROM INSIDE HOOD LOCK WINDSHIELD TABS
CHAIN GUARD
Disassembly and Assembly WARNING
Engine should be running only with chain guard well secured in place
WARNING
Naphtha is flammable and explosive under certain conditionsAlways manipulate in well ventilated areaDo not smoke or allow open flames or sparks in the vicinityPosition the windshield no1 on the hood no2 then push it down until the tabs are fully inserted into the hood slots, as shown