2001 Ski-Doo Mini Z Factory Shop Manual, Page 144Get this manual
Section 09 BODY AND FRAME Subsection 02 (BODY)
INSTALLATION AND ADJUSTMENT HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam is 25 mm (1 in) below the headlamp horizontal center line, scribed on test surface, 381 cm (12 ft in) awayMeasure headlamp center distance from groundScribe line at this height on test surface (wall or screen)Light beam center should be 25 mm (1 in) below scribed lineBULB REPLACEMENT
Headlight
If headlamp bulb is burnt, tilt hoodRemove the rubber boot and turn the bulb retainer ring counterclockwise
A31E0BA
REMOVE RUBBER BOOT AND BULB RETAINER RING
A31E0DA
1Headlamp center line A381 cm (12 ft in) B25 mm (1 in) below headlamp center