2001 Ski-Doo Mini Z Factory Shop Manual, Page 139Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
A31G0AA
A47 mm (1-2732 in) maximum
A31G08A
TO REMOVE CLIP LIFT THEN PULL OUT
Detach short tie rod end from steering arm no10Check that handlebar is horizontal and that skis are aligned with trackRotate tie rod end CW or CCW until proper alignment with steering arm is attainSee next photo
Restrain tie rod while firmly retighten nuts so that ball joint sockets run parallel with steering arm and pivot arm
WARNING
Ball joint sockets must run parallel with steering arm and pivot armTie rod must be restrained when tightening lock nutsEnsure that pivot arm no13 is still centered and check ski toe-outTOE-OUT Loosen lock nuts of long tie rod end no9 and detach tie rod end from steering arm no10Turn each tie rod end to adjust toe-outSee next photo