2001 Ski-Doo Mini Z Factory Shop Manual, Page 97Get this manual
Section 04 ENGINE Subsection 08 (CARBURETOR)
16,17, Float Valve
Remove float pin no10 then remove float no9 from carburetorCheck for worn valve seat on floatReplace if soCheck for weak float valve spring no17 or worn float valve, as shown in the next photo1 2
STANDARD FLOAT HEIGHT
13.7 mm (0.54 in)
If float height is not according to specifications on above table, replace float andor float valveRecheck float level height
INSTALLATION
To install carburetor on engine, inverse removal procedureHowever, pay attention to the following: Inspect throttle cable and housing prior to installation Ensure that both packings no18 and insulator no19 are properly positioned between cylinder head and carburetor, as shown in the next photo1 3
A31C0YA