2001 Ski-Doo Mini Z Factory Shop Manual, Page 70Get this manual
Subsection 04
Section 04 ENGINE (DISASSEMBLYASSEMBLY)
To reinstall bearings, reverse housing and use same tools as for bearings removal, as shown in the next photo
From inside crankcase, rotate governor arm shaft no14 then pull out governor slider no15 and washer no162 1
A31C2GA
A31C2IA
TO INSTALL BEARING
1Rotate governor arm shaft 2Remove governor slider with washer (not shown)
Governor System
Detach governor spring (black), throttle return spring and governor rod from governor armSee next photo3 1