2001 Ski-Doo Factory Shop Manual Volume Two, Page 254Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
Finishing Carefully hand or machine sand with 80 grit paper Cover with TP-E epoxy mixed in equal quantitiesNever use polyester fillers over formula 21 After 30 minutes, sand with fine 220 or 320 grit paperWipe or blow-off area Prep for paintApply Crest AF-S Flex Stik to aid in paint adhesion Prime and paint, following manufacturer's recommendations or use Crest Prima Flex and one of Crest's Flexible Bumper Coats AF1-18
Apply light coat of Crest AF-S Flex Stik Adhesion PromoterAllow 10 minutes to dry Install 50 mm (2 in) paper tape Crest noRPT on rear of repairA30H27A
1Paper tape
Large Crack
Preparation Clean repair area with Crest AS-X or BS-X Super SolvAllow to dry thoroughly
Apply Crest Formula 21 CF-PR Universal Plastic Repair directly to the repair area (to just beyond pinning holes)Allow 30 minutes cure time before sanding1
A30H28A
1Fill area between tape and pinning holes
A30H24A
CROSS SECTION OF TORN HOOD
Restore shape of plastic with heat gun, avoid overheating, let cool Enlarge area to be repaired, bevel, soften edges on both sidesAvoid smearing or melting the plastic