2001 Ski-Doo Factory Shop Manual Volume Two, Page 206Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
Enter new calibration number and press ENTER, following screen appears:
O AT SUCCESSFULL PLUG-IN KEY TO END: PRESS ANY KEY
A00A5OA A00A3EA
Press any key, screen:
Trs will show followed by next
Simultaneously with the following operation transfer will occur: TrsAt this point, be ready to rev the engine so it won't fall below the 2000 RPM mark when not using bypass wire or 9-volt adaptorPlug-in the desired calibration cartridge (special red key) onto the programmer post, the following screens will appear temporarily:
1TIMING ADJUST 2ENGINE SERIALAT N