2001 Ski-Doo Factory Shop Manual Volume Two, Page 174Get this manual
Section 05 TRANSMISSION Subsection 06 (BRAKE)
REMOVAL
BRAKE DISC REMOVAL Brake disc can be withdraw without removing caliperProceed as follows: Remove belt guard, belt and driven pulley Remove air silencer Unbolt bearing support no4 from chassis Unbolt caliper from chaincase Open chaincase and remove upper sprocket Pull countershaft no3 toward driven pulley side to free from chaincase and disc Remove disc
DISASSEMBLY
Only brake pads are available as spare partsIf caliper or master cylinder are damaged, replace each of them as an assembly
A15D03A
TYPICAL 1Fixed pad 2Inner caliper A1 mm (132 in) minimum
CLEANING
Clean all metal components in general purpose solventThoroughly dry all components before assemblingCAUTION: Do not clean brake pads in solventSoiled brake pads must be replaced by new ones