2001 Ski-Doo Factory Shop Manual Volume Two, Page 160Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
CAUTION: Bushing must be bonded with retaining compoundApply retaining compound Loctite 609 outside of bushing then press it down to counterbore from outside endCAUTION: Insert bushing from sliding half side (inner side) of spring cover
21,22,23, Ramp, Dowel Tube and Screw
Insert dowel tube from chamfered sideMake sure ramp is centered on dowel tubeASSEMBLY
NOTE: This drive pulley is lubrication freeDo not lubricate any component
A16D08A
1Chamfered side
1,2,3, Screw, Ring Gear and Loctite 271
Apply Loctite 271 (PN 413 702 900) on threads and then torque to 27 Nm (20 lbfft)