2001 Ski-Doo Factory Shop Manual Volume Two, Page 128Get this manual
Section 04 ENGINE Subsection 05 (OIL INJECTION SYSTEM)
Check that oil in small oil lines has been sucked up (this will be indicated by clear section of small oil lines)Repeat the procedure until this condition is attainedReconnect small oil lines, start engine and run at idle while holding the pump lever in fully open positionOil columns must advance into small oil lines
Test Bench Connect hose filled with injection oil to main line fittingInsert other hose end in an injection oil containerUsing clockwise rotating drill rotate pump shaftOil must drip from outer fittings while holding lever in fully open positionIf not replace pump2 1
A06C3LA
TYPICAL 1Fully open position 2Clockwise rotating drill 3Main line
4, Check Valve