2001 Ski-Doo Factory Shop Manual Volume Three, Page 257Get this manual
Section 08
STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
12, Steering Arm
The steering arm angles should be equal on both sides when skis are parallel with vehicleSteering arm axis (from plastic cap center to ball center of ball joint) must run parallel to ski
17,18, Ball Joint (left hand and right hand threads)
Inspect ball joint ends for wear or looseness, if excessive, replace them
HANDLEBAR ADJUSTMENT
Loosen all nuts no4 retaining steering clamps no2Adjust the steering handlebar to the desired positionLock the handlebar in place by tightening the nuts as specified in the illustrationsCAUTION: Tighten the nuts equally in crisscross sequence and ensure there is an equal gap on each side of the clamps
A32G0PA
TYPICAL 1Parallel
Tighten the steering arm pinch bolt and nut to the torque specified in the exploded view