2001 Ski-Doo Factory Shop Manual Volume Three, Page 255Get this manual
Section 08
STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
MX and Summit After grip installation apply few drops of Loctite 495 (PN 293 800 021) 10 mm (38 in) deep between grip and handlebarLocate former rivet hole in handlebar then, drill 4.8 mm (316 in) diahole through grip in this positionInstall rivet no3
16, Cut-Out Switch
Push on switch to remove plastic cover.A32G0NA
Disengage carriage bolts no6 from chassisDisengage carriage bolts no5 from steering support then, pull steering column from topPlastic U-clamps will come out along with steering column
12, Steering Arm
To maintain correct steering geometry for reassembling, scribe mark the steering arm and ski leg before disassemblyA32G0QA