2001 Ski-Doo Factory Shop Manual Volume Three, Page 232Get this manual
Section 07 REAR SUSPENSION Subsection 02 (SC-10 II SUSPENSION)
If the seal carrier assembly is replaced, use seal pilot to guide seal over damper shaftLubricate seal carrier guide pilot before useCAUTION: Failure to use seal pilot will result in seal damageReassemble damper rod assembly, taking care to properly assemble shim packs as required for your dampening needsEnsure that the shaft piston is installed with the slitslarger intake holes facing the rebound shim stack
A32F1WA
Damper nut Spacer Stopper with its round edge facing nut Shim pack
CAUTION: The damper rod nut can only be reused times, then, must be replacedDo not substitute this part for non O.E.Muse Loctite 271 on nut each timeThis (these) spacer washer(s) must be used as shown to ensure damper rod nut does not bottom out or contact shaft threadsRebound valve stopper with round edge facing nutNOTE: Rebound shim stack must not reach into threads of damper shaftSpacer under damper shaft nut is used to prevent damper shaft nut from bottoming on threads