2001 Ski-Doo Factory Shop Manual Volume Three, Page 218Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
IGNITION SYSTEM TESTING (ZX SERIES 290 W) PART TEST TO BE PERFORMED Running insulation Continuity in stop position Insulation in stop position DESS switch Running continuity Output Ignition generator coil Coil insulation Ground continuity Trigger coil MPEM Resistance and output WIRE COLOR BK and BKYL BK and BKYL BKGN and BKWH BKGN and BKWH RD and BKRD BK and RD BK and engine WHYL and BLYL WHBL and BK WHBL and BK MULTIMETER PROBE CONNECTION 11-DB-C-F 11-DA-3-F 11-DB-C-F 11-DA-3-F 11-DA-2-F 11-DA-1-F 11-DA-2-F 11-DA-1-F 11-DB-A-F 11-DB-B-F 11-DB-A-F 11-DB-C-F 11-DB-C-F and engine 11-DC-2-F 11-DC-1-F 11-DD-1-F 11-DD-2-F 11-DD-1-F 11-DD-2-F RESISTANCE VALUE MULTIMETER (OHMS) SCALE 0.L 00.000.5 0.L 00.000.5 11.621.6 0.L 00.000.5 190300 00.000.9 00.0 00.0 00.0 00.0 00.0 00.0 00.0 00.0 00.0 VOLTAGE VALUE MULTIMETER (VOLTS) SCALE 15.030.0 .200.350 25.0100.0 00.0Vac .000Vac 00.0Vac NOTE No stop switch must be in run positionOnly one stop switch must be in run positionTest one at timeTether cord cap should be offTether cord cap should be in place The term "engine" refers to the engine metal parts connected to the magneto housing No switch must be in run position and tether cord cap must be in place