2001 Ski-Doo Factory Shop Manual Volume Three, Page 205Get this manual
Section 06 ELECTRICAL Subsection 05 (ELECTRIC STARTER)
The radial play should not exceed 0.20 mm (.008 in)If greater, replace bushing as follows: Using 12 mm tap, cut threads into bushing so that the tap contacts the end frameContinue to rotate tap until the bushing comes free2 1
A19E0BA
A19E03A
Press-in Bushing pusher Bushing Drive housing
1Turn until bushing goes out 212 mm tap
Install bushing cover no19 then, using punch, stake bushing cover in place
To install new bushing, use the same bushing pusher as for drive housing bushing installation