2001 Ski-Doo Factory Shop Manual Volume Three, Page 204Get this manual
Section 06 ELECTRICAL Subsection 05 (ELECTRIC STARTER)
REMOVAL
Disconnect BLACK ground cable from battery Disconnect RED positive cable from battery
WARNING
Always disconnect ground cable first and connect last Remove tuned pipe Disconnect RED cable and REDGREEN wire from starter relay Disconnect ground cable from MAG side bracket Unbolt starter from PTO side bracket Unbolt MAG side bracket from engine Remove starter from engine
A19E01A
TYPICAL
A32E0MA
Twist screwdriver to separate stop collars no12 thus giving access to circlip no13Remove outer collar, circlip then inner collarRemove overrunning clutch no11Check the wear on bushing no18 by measuring the amount of radial play between the armature shaft and the bushingThe radial play should not exceed 0.20 mm (.008 in)If greater, replace the bushingTo replace, press out the old one toward bushing cover and press in new one with bushing pusherThe correct size of the bushing pusher to use is given on next illustrationCAUTION: Support drive housing adequately to prevent damage when pressing bushingA B