2001 Ski-Doo Factory Shop Manual Volume Three, Page 175Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
REMOVAL
Remove guard and drive belt from vehicleRemove cap screw no12 and shouldered washer no11 then pull the driven pulley from the countershaftNote shouldered washer position for reinstallationTake care not to loose spacer no21 2
529 018 600
A30D0IA
Remove snap ring no3 and washer no4 to disassemble the cam and the two pulley halves
WARNING
A30D0HA
Driven pulley cam is spring loaded, use abovementioned tool