2001 Ski-Doo Factory Shop Manual Volume Three, Page 110Get this manual
Section 04 ENGINE Subsection 02 (493, 593, 693 AND 793 ENGINE TYPES)
Spread seam of to mm (116 to 18 in) maximum in diameter on surface of lower crankcase half
Screw all crankcase bolts in place in the following sequence and to the appropriate torque through two steps torquing: first, screw bolts up to 60 of the final torque (18 Nm (13.5 lbfft) for most of the bolts), then, tighten to the required torque (i.e29 Nm (21 lbfft))B 18 11 14 16 19 8