2001 Ski-Doo Factory Shop Manual Volume One, Page 336Get this manual
Section 11 WIRING DIAGRAMS Subsection 01 (WIRING DIAGRAMS)
Waterproof Connector Housing
Female Connector Housing To remove: Insert tool Snap-on TT 600-5 under lock and twist to lift itA01E34A
Pry tab to free connector then pull wire out of housing
A01E31A
Pry tab to free connector then pull wire out of housing
A01E35A
MALE CONNECTOR HOUSING CUT-AWAY
TAB AND RECEPTACLE CONNECTORS INSTALLATION
Prior to installing, make sure locking tab is sufficiently lifted to properly lockInsert tab and receptacle connectors in their respective housings as shown in following illustrationsPush sufficiently so that they snapTry pulling wire to ensure they are properly locked