2001 Ski-Doo Factory Shop Manual Volume One, Page 315Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
WARNING
Before installation, ensure that all cables are in perfect conditionProperly install the cable ends and secure them in placePay attention to route them properly, away from any rotating, moving, heating, or vibrating parts
PLASTIC MAINTENANCE AND REPAIR MAINTENANCE
Clean the vehicle thoroughly, removing all dirt and grease accumulationTo clean use soft clean cloth and either soapy water or isopropyl alcoholTo remove grease, oil or glue use isopropyl alcoholCAUTION: Do not apply isopropyl alcohol or acetone directly on decalsCAUTION: The following products must not be used to clean or wax any of the plastic components used on the vehicles: gasoline brake fluid kerosene diesel fuel lighter fluid varsol naphtha acetone strong detergents abrasive cleaners waxes containing an abrasive or cleaning agent in their formulaApply wax on glossy finish onlyProtect the vehicle with cover to prevent dust accumulation during storageCAUTION: If for some reason the snowmobile has to be stored outside it is preferable to cover it with an opaque tarpaulinThis will prevent the sun rays from affecting the plastic components and the vehicle finish