2001 Ski-Doo Factory Shop Manual Volume One, Page 314Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
To remove decal; heat old decal with heat gun and peel off slowlyUsing isopropyl alcohol, clean the surface and dry thoroughlyApply liquid soap to new decal and carefully position the decalUsing sponge or squeegee, remove the air bubbles and surplus water working from the center toward the edgesAllow to air dryCAUTION: Do not apply isopropyl alcohol or solvent directly on decals
WINDSHIELD INSTALLATION
Position the windshield on the hood then push it down until the tabs are fully inserted into the hood slotsLock the windshield tabs in position using latches as shown
A03H14A
1Access hole
At installation, loosely install nuts, close hood then adjust before tightening interior nuts through access holes
BELT GUARD
Disassembly and Assembly