2001 Ski-Doo Factory Shop Manual Volume One, Page 300Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
HANDLEBAR POSITION ADJUSTMENT
All Models Remove steering padLoosen nuts on steering clamps no2Adjust the steering handlebar to the desired positionLock the handlebar in place by tightening the nuts as specified in the illustrationsCAUTION: Tighten the nuts equally in crisscross sequence and ensure there is an equal gap on each side of the clamps no2
WARNING
Make sure that the steering pad and all controls are properly fixed to their normal location on the handlebarA09G05A
TYPICAL 1Rubber attachment 2Nut and bolt (where applicable)
STEERING ADJUSTMENT (SKIS)
Definitions
TOE-OUT: difference measured between the front edge of the skis and rear edge as viewed from the topIt is adjustable