2001 Ski-Doo Factory Shop Manual Volume One, Page 289Get this manual
Section 07 REAR SUSPENSION Subsection 04 (DRIVE AXLE)
The maximum desynchronization for the sprockets is 1.5 mm (116 in)To check this tolerance, place axle assembly on plane surface and measure the gap between sprocket tooth and surface
5,12, Bearing
Always push bearing by inner raceA00F0AA
A00F0DA
1Plane surface A1.5 mm (116 in) MAXIMUM
CAUTION: The same sprocket must not be pressed twice on the axleIf synchronization is found to be defective, use new sprocket
The bearing on the splined side of axle must be pushed until it is seated on shaft shoulderThe end bearing housing bearing must be flush with end of drive axleEach bearing must have its shield facing the sprocket1 1
6,8, Drive Axle and Seal
When assembling drive axle, always position new seal on each end of drive axle (if applicable)Locate seal lip as illustrated1 2