2001 Ski-Doo Factory Shop Manual Volume One, Page 278Get this manual
Subsection 02
Section 07 REAR SUSPENSION (SC-10 SUSPENSIONS (ALL VERSIONS))
DISASSEMBLY AND ASSEMBLY
Inspect track thoroughly before reinstalling suspensionRefer to TRACK
Note position of axles at disassemblyAxles with paint stripe serve as idler wheel axlesThese are more precise than those used as pivot axlesIdler wheel axles can be used as pivot axles but the opposite is not true
1, Rear Arm
At installation, rear arm stroke limiter must be on rear side12,13,14, Front Shock, Spring Stopper and Cap
Use shock spring remover (PN 529 035 504) and put it in viseMount shock in it and turn shock so that spring coils matched spring compressorClose and lock barAdjust handle horizontal by changing position of clevis pinPush down on handle until it locksRemove spring stopper and cap then release handle