2001 Ski-Doo Factory Shop Manual Volume One, Page 262Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
IGNITION SYSTEM TESTING (Skandic WTSWT) RESISTANCE VOLTAGE TEST TO BE WIRE NOTE PART VALUE MULTIMETER VALUE MULTIMETER PERFORMED COLOR (OHMS) SCALE (VOLTS) SCALE Running BK and All switches must be 00.0 0.L insulation BKYL in run positionStop At least one stop switch Continuity in BK and 00.0 00.000.5 switch must be operstop position BKYL ationalWH and 230.0 30.0 All switches must be 00.0 Output 00.0VAC Ignition GN 330.0 60.0 in run positiongenerator Ground WH and coil 00.0 00.000.5 The term "engine" recontinuity engine fers to the engine metRDWH al parts connected to 140.0 Trigger VAC 00.0 Continuity and 2.09.0 00.0 the magneto housing180.0 coil engine Ignition Secondary module 13.1 winding CAUTION: Do not measure high voltage coil 00.0 and high output voltage18.3 resistance voltage with caps coil Spark Secondary plug cap 8.90 winding CAUTION: Do not measure high voltage coil 00.0 output voltage13.1 Spark resistance plug cap with caps Secondary High BK 0.90 winding CAUTION: Do not measure high voltage coil 00.0 voltage output voltageBK 1.10 resistance coil without caps The measurement Secondary BK .100 must be taken on the VAC winding 0.00 engine .250 spark plug cable (withvoltage out the spark plug)Spark Cap 00.0 4.06.0 plug cap resistance