2001 Ski-Doo Factory Shop Manual Volume One, Page 261Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
2Connect multimeter probes to GREEN and WHITEwires (female end), then bring selector to and VACscale to 00.0 3Activate the manual starter and check values indicated by the multimeter4Repeat operation times
LIGHTING GENERATOR COIL VOLTAGE TESTING
NOTE: The lighting generator coil is not part of the ignition systemIt is self-contained system used to supply current to the lighting system and to other devices working on alternating currentHowever, this system can be tested using multimeter1Disconnect housing from engine (2-01)2Connect multimeter wires to YELLOW and YELLOWBLACK wires (female side), thenplace selector switch to and scale to 0.00VAC3Activate the manual starter and check values indicated by the multimeter4Repeat operation times
A03E1JA
5Compare readings with those appearing in the IGNITION table
5TRIGGER COIL VOLTAGE TESTING
1Disconnect 4-wire housing between the ignition module and the engine (4-02)2Connect multimeter probes to REDWHITE wire (female side) and to the engine, then bringselector switch to and scale to 00.0VAC3Activate the manual starter and check values indicated by the multimeter4Repeat operation times5Compare readings with those appearing in the IGNITION tableA03E1LA