2001 Ski-Doo Factory Shop Manual Volume One, Page 254Get this manual
Section 06 ELECTRICAL Subsection 05 (ELECTRIC STARTER)
Install overrunning clutch onto armature shaftInsert inner collar onto shaftInstall new circlipCAUTION: Always install new circlip when servicingInsert outer collar being careful to match protrusions with notches of collarsUsing pair of pliers on each side of stop collars, squeeze evenly until collars sit over circlip
A03E05A
TYPICAL 1New 2Wear limit
Overrunning Clutch
The pinion of the overrunning clutch should turn smoothly in clockwise direction, and should not slip in counterclockwise directionIf defective, replaceCheck the pinion teeth for wear and damageIf defective, replaceA19E07A
1Squeeze evenly