2001 Ski-Doo Factory Shop Manual Volume One, Page 211Get this manual
Section 05 TRANSMISSION Subsection 06 (BRAKE)
To install bearing on countershaft, use remover (PN 529 030 100) and some flat washers of mm (18 in) total thicknessUsing original retaining screw and shouldered washer tighten until bearing rests against circlip
5,12, Brake Cable and Nut
Insert brake cable into upper hole in brake lever and caliperInstall nut and tighten until few threads exceed
WARNING
At least threads must exceed the elastic stop nut
ADJUSTMENT
Models with Mechanical Brake Fully depress brake handle several times to obtain 13 mm (12 in) between brake handle and handlebar grip when brake is fully applied.A03D32A
529 030 200