2001 Ski-Doo Factory Shop Manual Volume One, Page 210Get this manual
Section 05 TRANSMISSION Subsection 06 (BRAKE)
ASSEMBLY
14, Ratchet Wheel
Apply synthetic grease (PN 413 711 500) on threads and spring seat prior to installingFully tighten then back off one turn
7, Brake Pad
Models with Hydraulic Brake After brake pads installation, brake disc must be centered in caliperApply brake then check for proper brake disc positioningPush on appropriate caliper piston in order to move pad inward allowing proper brake disc positioning
Install so that it can only be removed upwardLock it in the caliper casting notch
INSTALLATION
To install brake, reverse removal procedure paying attention to the following
WARNING
Avoid getting oil on brake padsDo not lubricate or apply antirust or antifreeze solution in brake cable
17, Brake Disc