2001 Ski-Doo Factory Shop Manual Volume One, Page 195Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
Use holderSee removal procedureTorque screw to 90 to 100 Nm (66 to 74 lbfft)Install drive belt and guardRaise and block the rear of the vehicle and support it with mechanical stand
WARNING
Ensure that the track is free of particles which could be thrown out while track is rotatingKeep hands, tools, feet and clothing clear of trackEnsure nobody is standing near the vehicleA16D0EA
Carefully slide governor cup into sliding halfAlign mark of governor cup with mark of fixed halfRemove forks and push governor cup so that its splines engage with fixed half shaft splinesCAUTION: Make sure splines of both parts are fully engaged
Accelerate the vehicle at low speed (maximum 30 kmh (20 MPH) and apply the brake, repeat timesRecheck the torque of 90 to 100 Nm (66 to 74 lbfft)
WARNING