2001 Ski-Doo Factory Shop Manual Volume One, Page 127Get this manual
Section 04 ENGINE Subsection 03 (593 ENGINE TYPE)
Coat inner side of seal and set it in place
Drop 50 mL (2 U.Soz) of injection oil in the pan under central gear to lubricate pump gearing as per photo
A32C0BA
A32C0DA
1Fill with grease and set in place
Use the remaining grease to coat the inner side of the ball bearing
1Oil bath
Crankcase Assembly IMPORTANT: The total assembly sequence, including sealing compound spreading, screwing and torquing of bolts according to the proper sequence must be performed within 10 minutesBefore screwing both parts of crankcase, seal it with sealing compound (PN 420 297 905)Make sure surfaces are clean and degreased before applying sealing compoundSpread seam of 1.2 mm (116 in) maximum in diameter on surface of lower crankcase half