2001 Ski-Doo Factory Shop Manual Volume One, Page 16Get this manual
INTRODUCTION
5Install stud6Install cover, etc7Apply drops of proper strength Loctite on uncovered threads8Tighten nuts as required
Preassembled Parts
1Adjust screw to proper setting2Apply drops of proper strength Loctite threadlocker on screwbody contact surfaces3Avoid touching metal with tip of flaskNOTE: If it is difficult to readjust, heat screw with soldering iron (232C (450F))
STRIPPED THREAD REPAIR
Stripped Threads
A00A3OA A00A3QA
1Apply here 2Do not apply