2001 Ski-Doo Factory Shop Manual Volume One, Page 15Get this manual
INTRODUCTION
SELF-LOCKING FASTENERS PROCEDURE
The following describes the most common application procedures when working with self-locking fastenersUse metal brush or screwtap to clean the hole properly then use solvent (Methyl-Chloride), let act during 30 minutes and wipe offThe solvent utilization is to ensure the adhesive works properly
Blind Holes
LOCTITE APPLICATION PROCEDURE
The following describes the most common application procedures when working with Loctite productsNOTE: Always use proper strength Loctite product as recommended in this Shop ManualA00A3MA
1On threads 2On threads and at the bottom of hole
THREADLOCKER
Uncovered Holes (bolts and nuts)